Concrete Remedy TS

Concrete Remedy Top Seal is a nontoxic, non-flammable, penetrating surface sealer that completely seals and waterproofs most concrete, stamped concrete, brick, cured asphalt, stucco and sandstone surfaces.

Concrete Remedy TS is effective as a sealer on surfaces which will be above or below grade.

Top Seal can be used alone, as a single product or it can be used in conjunction with Concrete Remedy DS -- an internal densifier and hardener that also waterproofs and reduces vapor transmission.

Click to See How Deep Seal & Top Seal Work Together

If you have questions about when and where to use Top Seal, or how Top Seal and DS can be used together please email or call and I will personally help you know which is the best approach for your speficic application. Contact info at bottom of page.

Top Seal penetrates approximately 1/16th inch into concrete. Penetration rates vary according to the substrate. Concrete Remedy DS works only internally, and leaves the top 1/16th inch clean so that other coatings or adhesives or penetrating sealers will work well.

Click For Detailed Technical Reports on a variety of applications for DS

Either as a "stand alone" single product for sealing all types of surfaces, or in conjuction with Concrete Remedy Deep Seal, Top Seal is the

Perfect Solution for:

Stamped Concrete Top Seal is particularly well suited to protect Stamped Concrete. Often it is colored. Top Seal will not change the look or color of stamped concrete.

A second big advantage to using Top Seal on stamped concrete is that it does not make the concrete as slick as surface coatings will. Any time you put on a surface build material that gives a shiny or glossy appearance, you can be sure that surface will be slick when it gets wet.

Slickness and safety are a huge issues in commercial settings. Top Seal avoids this problem because it is a penetrating sealer and NOT a surface build material.

Stucco Houses and Buildings Stucco walls tend to absorb moisture. The results of moisture passing into and through stucco include mold and mildew growth. All the moisture problems associated with stucco can be solved by patching cracks if needed and applying Concrete Remedy DS and Top Seal. Concrete Remedy DS also hardens, strengthens and dust proofs stucco so it lasts longer.

Other Popular Uses

Concrete
Brick structures
All kinds of tile floors and walls
Asphalt Shingles
Sidewalks, Curbs and Gutters
Paving Stones
Granaries
Patios
Sewage Treatment Plants
Zoo, Barn and Concrete Floors
Garage Pads and Driveways
Service Stations
Pools
Car Wash walls

ADVANTAGES

Very Easy One coat application
Never any "peeling" or chipping -- maintains a good, natural appearance
Leaves clear, non-glossy finish
Does not produce the extreme slipperiness that surface build, shiny materials will. Top Seal is safer in business and commercial settings.
Will not alter color or texture
Impervious to penetration of grease, oils, acids and salts
Stops pitting, rutting, dusting and molding
Enables easier ice and snow removal
Enables easy clean up of spills with mild soap and water

COVERAGE RATES
Coverage rates with Concrete Remedy TS depend on the porosity of the surface being treated. I.e. concrete floors finished with a power trowel then treated with Concrete Remedy DS will use much less Concrete Remedy TS than paving stones which have never been treated with anything and have visible pores.
Coverage can range from 100 to 300 square feet per U.S. gallon.

CAUTION - PLEASE NOTE

Top Seal should not be used if the surface is going to later be painted or coated over. Coatings will not stick to Top Seal without specific surface preparation.

Do not apply Concrete Remedy TS to glass, glazed surfaces, or aluminum, as etching will occur. In case of accidental contact, rinse thoroughly and immediately with water.
Concrete Remedy TS is not meant to fill or seal visible cracks.
For surfaces not specified in our literature or if you are uncertain as to previous chemical treatments, (on the surface to which you are considering applying Concrete Remedy TS), we recommend that Concrete Remedy TS be applied to a small test area first.
DO NOT ATTEMPT A SECOND COATING OF Concrete Remedy TS!
If Concrete Remedy TS becomes frozen, thaw out completely and shake well to fully remix the material prior to using. Freezing will not harm the product.

Disclaimer and a Promise

SolvingConcreteProblems.com and Concrete Remedy believe this information to be true to the best of our knowledge. Our products are of the highest quality and uniform within manufacturing tolerances.

Since no direct control is exercised over product use, no warranty, expressed or
implied, is made as to the suitability of products for a particular use or as to the effect of such use, and no liability is assumed, directly or indirectly.

In the event products received were defective at point of manufacture, replacement will be made at no cost to purchaser.

Buyers and users are encouraged to conduct their own tests prior to
application.

Please be assured that we will go the extra mile in helping you solve or prevent problems. We will provide thorough and detailed technical assistance and help you at every step of the way to guarantee that you get a permanent and cost beneficial solution.

We have the resources and availability to help you with on site evaluations and consultations. Or if you prefer to not use your resources for application, we are ready and able to complete all the work for you. In the event you want to do the actual work yourself, we can provide on site technical assistance and guidance if you want that level of assistance.

I will personally make sure you get what you need.

Thank you for visiting my site.

Click here to download a Concrete Remedy TS brochure in Adobe .pdf format.

Click here to download the Concrete Remedy TS MSDS sheet in Adobe .pdf format.

Click here to download How Deep Seal & Top Seal Work in Adobe .pdf format.

To read Adobe .pdf files you must have a copy of Adobe Acrobat Reader. If you don't have the Adobe Acrobat reader, you can download it for free. Click on the link below: